Type R Club of America

The OEM ones are supposedly still available, however, I’ve been waiting on some that I had ordered back in July (so take that with a grain of salt). They are expected to be in stock in 10/31, but will see how it goes.

Thanks for the thumbs up! As far as the decision to run 0W30, honestly, despite what conclusions you might draw about my personality from the thread, I'm not as concerned as I used to be about oils and all that. I figure chances are that the car will meet it's end going off track or more likely hit ...

Trans and Engine UOA

So far nothing too wild this year Maintenance: Replaced engine air filter Trans fluid change in March w/ Honda MTF (w/ UOA) Replaced driver's side axle with a Raxle replacement at about 134160mi (the inner boot tore during a track weekend in May). Engine oil replaced in June w/ Amsoil 0w30 (w/ UOA) ...

Engine UOA https://drive.google.com/uc?id=1JZs9PX6iY9wl9Qo2bO1nD_7fV9p0ahP1 Dent & PDR results https://drive.google.com/uc?id=10tA91MMwyv7-p5Nao9Y-s9ctbloVJuN1 https://drive.google.com/uc?id=1Lv94kL3ywq-w36wsNfF51Uh6sbRpsy-G https://drive.google.com/uc?id=1dS-03JQtCZnx1i6LsolVybbGDNpaOmzM After ...

Nothing too wild and crazy this year. A buddy of mine and I picked up a project car last year to be a track rat (a 91 EF hatch with an H22 swap), so spend a lot more time wrenching on that one than on the ol' ITR this year. Still, went to a few track days and the car was holding up well post head re...

Hm, it’s hard to tell from the image if they’re exactly the same, but I’m sure they’re pretty close (I mean, it’s a seat bottom. How different can they be?). My concern is that there might be some side-specific contours that might result in a lumpy/uneven seat if the sides foam bits are swapped. And...

Thanks guys. I’ve seen some how-tos for repairing the seat foam, so I guess that’s the route I’ll go at some point. I was hoping to just buy the part and swap it as my inexperience in foam fabrication likely will add cycles to the task... And really, deep down, it’d be nice peace of mind to have som...

Hey folks, I'm looking to replace the driver's side seat's foam in the bottom part of the seat. I did a quick check on a few parts sites and it looks like the OEM ITR seat bottom foam, 81532-ST7-J21, is discontinued, however the non-ITR models part, 81532-ST7-A01, is still available. If memory serve...

The dent actually came out pretty well, so again, hats off to the PDR experts... that trade is simply magic to me. In a few angles, I can tell where it's not quite 100% perfect (it's like 97.5% perfect), but I'm very pleased that it's taken a blemish easily spotted at 6ft, and turned it into a 6inch...