ITR 00-0874 ... Life after death

[Stin1]

The actual lights for the fog light are the same as the 99-00 civic. It’s a different bracket.

[JDMJNKY]

Thanks for that confirmation brotha! I read that somewhere. That leaves us with more resources on replacement lights. The downside, is the bracket. The brackets, are what I wish to reproduce.

[Outrun]

I've been trying to find brackets to reproduce as the lamp housings are the same as a few other Hondas, like 99-00 Civics as posted above. The eBay listing was gone but glad you're the one that got it!

[JDMJNKY]

Yuppp! I managed to get the one on eBay! I’m hoping I can get the brackets made. If I can’t find someone locally, I might reach out to Raul from CS.

minor major updates... Vent, dash side plug, cluster & cluster bezel in.

IMG_5062.JPG (2.88 MiB) Viewed 234 times

[JDMJNKY]

Right around the time I started installing the climate control and vents I noticed the center support for the climate was missing. I had been searching the classifieds for a cheap dashboard, but I couldn’t find anything cheap enough to hack up. I hopped on LKQ last night and saw that they had a 2000 Integra on the lot - dropped 04/09/25. I went today, and these so-called Honda guys left the car a mess...... useable parts, now trash, as if they didn’t know how to take apart a 25 year old Honda. All the little trinkets I was looking for were there. The center console was clean, even though they had it in the dirt. However, right where you remove the cover for those two screws, there was a gouge from them removing it with a phillips :facepalm: The ignition cover plastics were thrown to the ground and scuffed up, door switches same thing, it was heartbreaking.... lol.


my attempt to make a support

IMG_5165.jpg (3.38 MiB) Viewed 46 times

the support i removed from the LKQ Integra, plastic welded it to my dash.

IMG_5217.jpg (4 MiB) Viewed 46 times

IMG_5218.JPG (2.1 MiB) Viewed 46 times

Finally swapped my rear bumper support

IMG_5171.jpg (2.72 MiB) Viewed 46 times

IMG_5173 2.jpg (3.11 MiB) Viewed 46 times

IMG_5174 2.jpg (2.83 MiB) Viewed 46 times

as i continue to hunt for really clean/new/mint trim pieces, I've set aside a few last resort pieces that have aged well.

IMG_5010 2.JPG (2.75 MiB) Viewed 46 times

[JDMJNKY]

Woke up early-ish this morning. I had planned to fix the passenger door and install the passenger panel today, but the wiring was an eyesore. A small setback, but as you read on, you'll see there were a few more trinkets missed. So, back to the JYard I went, on a quest to find an OEM connector! I know it shouldn't matter since I'm using a speaker jumper, but I didn’t like the idea of it not being plug n play like the driver side.

A lil backstory: While I was there yesterday, I snapped a photo of the SRS bracket. The SRS connector on the R was dangling, and I needed a reference as to why.

As I storm the castle, locked in on getting to this Integra, grabbing my SRS bracket, its clip, and the speaker harness, I notice another Integra. All the thoughts of wtf… run through my head: Did I see that yesterday? Did they just put it out? Why didn’t I notice it? Anyway, I told myself I'd check that one out on my way out.

Back at the silver 2000 Integra, I eyeballed the glovebox and consoles once more. Inevitably, I passed. If I'm gonna pay for it, I want it as clean as possible. Even if the car will be listed for sale, I can’t compromise on what I’d accept.

Onto the magical green Integra, that seemed to manifest from pure desire. It wasn’t anything special, tan interior with a few usable parts. Out of the previously scalped speaker harnesses in my hand, its wiring colors matched the R’s. So I snipped that one and discarded the other two.

Then, in a completely different row from where the car was, I stumbled upon its back bumper. It still had the license plate lights. I quickly undid those assemblies, since I was missing them too. While removing them, I felt kinda dumb, I'd just ordered some new and used pieces yesterday evening from FB and ebay. Talk about a lack of efficiency.

It gets worse.....as I button up today's work , I realized I got so anxious i forgot that I also needed the passenger door handle bracket and dome switch.

IMG_5237 2.JPG (2.39 MiB) Viewed 34 times

IMG_5238.jpg (2.7 MiB) Viewed 34 times

IMG_5239.JPG (2.05 MiB) Viewed 34 times

license plate lights, brackets cleaned with rust dissolver, primed, painted. Lenses polished.

IMG_5236 2.jpg (4.2 MiB) Viewed 34 times

IMG_5244.JPG (2.1 MiB) Viewed 34 times

IMG_5245.JPG (1.92 MiB) Viewed 34 times

I was not not looking for this, but happy that I found this lil guy looking for door panel clips

IMG_5247.JPG (3.27 MiB) Viewed 34 times

half ***** door panel hehe

tempImageAr0A0o.gif (4.54 MiB) Viewed 34 times

[Dave7CDMTYPER]

Lack of efficiency, I'm right there with you haha.

[JDMJNKY]

HAHA .... im going to blame it on getting old.