Re: DC2/DB8 QUESTIONS Type R project almost done
Posted: Sun Nov 05, 2017 12:01 am
I got 1170mm overall from flange to end of the tip. And 350mm from the back of the muffler itself to the end of the tip
I actually ordered a brand new yonaka brand shaft. Reviews were good and it was new. I have a new oem seal also ready to go and I will throw it back together. I just really hope it is not transmission related. My oem shaft was missing the brass washer but I don't think that was the issue.Purplepassiongsr wrote: ↑Sat Nov 04, 2017 9:46 pm A new intermediate shaft might be worth a shot if you're positive your using the right axle seal. Hmo has shafts for like $50. I had a similar issue but was due to getting the wrong axle seal sent to me, probably for a 36mm axle. The ID was too large and leaked trans fluid. Swapped out for the right one and not a drop after that. Good luck tracking it down