Page 29 of 37

Re: 98-1059 is here to stay

Posted: Sun Aug 18, 2019 10:11 pm
by 9701TypeR
The cut harness would normally go to the ABS ECU located in the passenger wheelhouse. There should be the ecu and mounting bracket and a large single plug if I recall correctly. Do you know why this was cut and not just unplugged?

Re: 98-1059 is here to stay

Posted: Mon Aug 19, 2019 6:27 am
by Sp00nFedFilms
9701TypeR wrote:The cut harness would normally go to the ABS ECU located in the passenger wheelhouse. There should be the ecu and mounting bracket and a large single plug if I recall correctly. Do you know why this was cut and not just unplugged?
I wish I could tell you. There’s no good reason for it.

Re: 98-1059 is here to stay

Posted: Tue Aug 20, 2019 2:35 pm
by Sp00nFedFilms
Nothing really exciting on my day off. Decided to slide by my local Acura dealer and see what came in. Believe it or not, I would’ve been more pleased to see the two lousy post mount nuts lol. ETA of 8/25 for them though.

My driver side fen fender liner has a few parts that it ripped away from it’s clips and it bothered me. Might as well grab them now before it goes on the extinct list.

Imagemm

Hood seal. Stin mentioned this to me a while ago. Just getting around to it.

Image

This completes my BNIB badging.

Image

Hoping the new hardware comes in yellow zinc.

Image

Re: 98-1059 is here to stay

Posted: Thu Aug 22, 2019 7:23 pm
by Sp00nFedFilms
After much searching for a new rear wiper seal seeing mine was faded, I came upon some info. At first glance at the FSM you’d think the piece I was looking for was called the rear wiper seal, but it’s not. It’s actually called the pivot cap. Good thing, because the seal is since been discontinued. Here is the pivot cap install.

Image

Image

Image

Image

Image

Image

Image

Image

Image

Image

Image

Image

Image

Re: 98-1059 is here to stay

Posted: Thu Aug 22, 2019 8:51 pm
by aklackner
Very Nice

Re: 98-1059 is here to stay

Posted: Sun Aug 25, 2019 11:23 pm
by Sp00nFedFilms
The long awaited. I finally found you.

Image

Re: 98-1059 is here to stay

Posted: Sun Aug 25, 2019 11:42 pm
by aklackner
Beautiful, we should find some one to make a run. :)

Re: 98-1059 is here to stay

Posted: Sun Aug 25, 2019 11:43 pm
by Sp00nFedFilms
aklackner wrote:Beautiful, we should find some one to make a run. :)
Probably not a bad idea if someone knows a machinist. I’m happy it came with the rubber stay, that’s extinct as well.

Re: 98-1059 is here to stay

Posted: Sun Aug 25, 2019 11:44 pm
by Sp00nFedFilms
Sp00nFedFilms wrote:
aklackner wrote:Beautiful, we should find some one to make a run. :)
Probably not a bad idea if someone knows a machinist. I’d offer it as a donor. I’m happy it came with the rubber stay, that’s extinct as well.

Re: 98-1059 is here to stay

Posted: Sun Aug 25, 2019 11:59 pm
by aklackner
Do you also have the sort of shaped in between piece, that’s bows between the rubber pictured and the rubber on the solenoid?