Page 1 of 1
Proper Splitter Mounting & Design
Posted: Tue Jun 09, 2020 6:29 pm
by coolhandluke
Starting a thread for proper splitter angle, goals, and mounting. To start the discussion:
https://www.youtube.com/watch?v=PFT6np9B48M
Re: Proper Splitter Mounting & Design
Posted: Fri Jul 17, 2020 2:23 pm
by Chase_acura
Re: Proper Splitter Mounting & Design
Posted: Sun Jul 19, 2020 12:29 pm
by g3teg97
Jon Sewell (@sewell6669) on Instagram was posting about this recently.
Interesting stuff.
Re: Proper Splitter Mounting & Design
Posted: Mon Jul 20, 2020 1:07 pm
by coolhandluke
g3teg97 wrote: ↑Sun Jul 19, 2020 12:29 pm
Jon Sewell (@sewell6669) on Instagram was posting about this recently.
Interesting stuff.
Thank you for sharing, this appears to be the recommended product above:
https://www.lowes.com/pd/EasyFlex-Black ... 1000126053
Re: Proper Splitter Mounting & Design
Posted: Mon Jul 20, 2020 2:57 pm
by RTW DC2R
Honed Developments has some excellent content on their IG acct. I highly recommend spending some time there if you are on the Gram.
https://www.instagram.com/honed_developments/
Re: Proper Splitter Mounting & Design
Posted: Mon Jul 20, 2020 3:15 pm
by coolhandluke
I'm a fan of Honed Developments overall, I purchased both their Rear UCA's and Roll-center correction kit. I would note their posts are trending away from engineering edu / why important and towards
buy our stuff. Classic,
mileage may vary.
Re: Proper Splitter Mounting & Design
Posted: Tue Jul 21, 2020 9:13 am
by g3teg97
coolhandluke wrote: ↑Mon Jul 20, 2020 3:15 pm
I would note their posts are trending away from engineering edu / why important and towards
buy our stuff. Classic,
mileage may vary.
I enjoyed reading their posts and learning the information they share even though I may not understand it completely the first time haha.