Type R Club of America

Looking for a USDM exhaust manifold so I can convert my 98 ITR back to stock. If you have one let me know...I'm willing to pay good money for one. Thanks! Mark

Would you be interested in one with no upper heat shield? I might be able to convince a friend to sell his.

shamola wrote:Looking for a USDM exhaust manifold so I can convert my 98 ITR back to stock. If you have one let me know...I'm willing to pay good money for one. Thanks! Mark

Hey man I know of someone who has a USDM exhausts manifold in excellent condition send him a private on alavesrandy@ gmail.com if you still interested in buying

Best Regards

colerami14 wrote: ↑Sat May 29, 2021 5:34 pm

shamola wrote:Looking for a USDM exhaust manifold so I can convert my 98 ITR back to stock. If you have one let me know...I'm willing to pay good money for one. Thanks! Mark

Hey man I know of someone who has a USDM exhausts manifold in excellent condition send him a private on alavesrandy@ gmail.com if you still interested in buying

Best Regards

Thank you for the heads up! I just sent him an email

touringteg wrote: ↑Thu May 27, 2021 3:27 pm Would you be interested in one with no upper heat shield? I might be able to convince a friend to sell his.

I am interested but do you know if the heat shield for the JDM 4-2-1 headers will fit the USDM header? They look similar but I don't know if they are interchangeable.

I test fit a 95-97 JDM ITR upper heat shield. The upper two bolts are close. You have may have to slightly open one up with a dremel. The lower hole did not line up so a new hole would have to be drilled. I am unsure if it would rattle or not once it is all bolted on.

I never got a chance to try the USDM GSR/Si B18C1 or B16 header heat shield. Those have 4 bolt holes for the shield and USDM ITR has 3.

Thanks Shamola for purchasing my friends CDM/USDM OEM exhaust manifold. It shipped out on Saturday.
I hope it arrives safe and sound!