Type R Club of America

2000 Acura Integra Type R · 63,400 miles

Location: Canton, GA

Price: SOLD

NO TRADES - Cash Only

I recently picked this car up from Shaun Cook in PA. Reason for selling, I got an opportunity to purchase back my 98 ITR that I sold 6 years ago.

Car has 63k miles on the odometer which is accurate based on the carfax entries.

This car has a rebuilt title from an accident reported in 2003. The Front bumper, fenders, hood, and driver door was replaced. More than likely airbags going off totaled the car and caused the rebuilt title need.

This car is a great solid running car! Clean inside and out!

Car has the following Modifications-
98 Spec ITR motor and Trans with 4.7 final drive. (Car has no CEL, does have OBD2a JDM computer)
Mugen Twin Loop Exhaust Mugen Gen2 Steering Wheel
Mugen Radiator Cap
Mugen Thermostat
Eibach Multi Pro R2 Suspension
Pioneer BT Headunit

Cons:
The front lip has a scrape on the passenger side and would need repainting
The bumper, driver fender, and door seem to lean more towards NHBP rather the OEM FBP
Paint overall is good, great for a driver but not show car ready.

Maintenance Items;
I had planned to do full service on the car. The timing belt, water pump, oil pan gasket, and rear main seal.
Runs and drives fine but seems to have a leak from oil pan gasket. Does not leak on the garage floor but seems to seep.

Very nice! Question on the wheels, using spacers or is this a replica itr wheel with lower offset? Fitment seems to be more squared than stock.

Good luck with your sale, glad to hear your buying your old itr back!

Na-spirit wrote: ↑Fri Jan 06, 2023 10:53 pm Very nice! Question on the wheels, using spacers or is this a replica itr wheel with lower offset? Fitment seems to be more squared than stock.

Good luck with your sale, glad to hear your buying your old itr back!

Thanks! My white car comes home next Sunday!

I’m running a 25mm front spacer and 20mm rear spacer. Wheels are OEM. Refinished. Not perfect color match but look great.

Car is sold as of today.

Dot_tom wrote: ↑Sat Jan 07, 2023 9:27 pm I’m running a 25mm front spacer and 20mm rear spacer. Wheels are OEM. Refinished. Not perfect color match but look great.

What brand spacers were on the car?

g3teg97 wrote: ↑Fri Jan 13, 2023 4:57 pm

Dot_tom wrote: ↑Sat Jan 07, 2023 9:27 pm I’m running a 25mm front spacer and 20mm rear spacer. Wheels are OEM. Refinished. Not a perfect color match but look great.

What brand spacers were on the car?

just some spacers I got off Amazon. They met the requirements, PCD and center bore.