J's Racing FX60RS Rear exhaust hanger options?
Posted: Mon Jun 25, 2018 1:23 pm
I have a J's Racing FX60RS and with the stock hangers it was sitting super low in the exhaust cutout. Me being particular I went and bought some shorter rubber exhaust hangers that had made the exhaust sit a bit further up.
Ever since I did that I've had issues with the rear two bolt gasket sealing properly and also getting some vibration from the b-pipe rattling against the stock heat shield.
Does anyone have a solution for this? Are there some good quality rubber exhaust hangers that are shorter than stock but allow for some sort of adjustment?
Thanks in advance for any advice.
-Ken
Ever since I did that I've had issues with the rear two bolt gasket sealing properly and also getting some vibration from the b-pipe rattling against the stock heat shield.
Does anyone have a solution for this? Are there some good quality rubber exhaust hangers that are shorter than stock but allow for some sort of adjustment?
Thanks in advance for any advice.
-Ken