98-0940 Anyone know anything about the caR?

[Stin1]

Screw you !!!!!

IMG_4327.jpg (268.72 KiB) Viewed 1634 times

This is what Acura provided for my cup / cubby hardware. This is what I think spoon received as well. This is the screw behind the door panel. Not only is it the wrong color for the cubby, and no washer, the threads are different.

[Stin1]

IMG_4323.jpg (122.27 KiB) Viewed 1631 times

New weatherstripping

[Stin1]

I think I figured it out.

IMG_4330.jpg (145.1 KiB) Viewed 1618 times

There's two pockets pictured in the parts diagram. The lower pocket should be pictured as a bracket for the pocket. The top one is the cup and screw.

[Stin1]

Can someone confirm what the original screw should look like?

[Stin1]

Happy Halloween ! The great pumpkin handed me this for 2019.

IMG_4574.jpg (130.88 KiB) Viewed 1576 times

IMG_4573.jpg (120.91 KiB) Viewed 1576 times

[coolhandluke]

Those are impressive cuts.

The 98 has been without door panel for at least 2 months or more. The vapor seal went in on the driver side. I used this tape instead of the nasty butyl glue. IMG_4324.jpgIMG_4326.jpg

Where did you purchase this tape? I am about to run through this process.

[Stin1]

Those are impressive cuts.

The 98 has been without door panel for at least 2 months or more. The vapor seal went in on the driver side. I used this tape instead of the nasty butyl glue. IMG_4324.jpgIMG_4326.jpg

Where did you purchase this tape? I am about to run through this process.

I got it at oreillys but google seemed to show Walmart and every auto store had it too .

[330R]

The door pull pocket uses a black tapping screw (90101-S03-000)

The door pocket at the bottom of the door consists of two pieces and is attached with two screws (93913-14220) installed behind the door lining.

[Stin1]

The door pull pocket uses a black tapping screw (90101-S03-000)

The door pocket at the bottom of the door consists of two pieces and is attached with two screws (93913-14220) installed behind the door lining.

Thanks for that! Mark said that you checked and confirmed no washer on the black screw for the pocket correct? I didn't even think of that lower pocket.

[330R]

Hmm I didn’t speak with spoonfed about it. But that’s correct, no washer on the black screw. I haven’t had a Teg door panel off in years so can’t remember what the bottom pocket screws look like... probably like the silver screw pictured above, just different part number.