T.W. Lots of ITR parts

[AndyD]

Located in Maryland

Hey guys,

This post is to test the waters to see how much interest there is. Let me know if you're interested in anything and we can go from there.

I have been collecting parts over the past 4 years for 3 reasons; To rebuild a future stripped ITR shell, to get ahold of OEM parts for the community before they were discontinued, and to get ITR parts back onto ITRs. My #1 goal was to get these parts back on ITRs in some way.

I have an opportunity to buy an ITR that's mostly complete. So i think it's time to let go of the parts I've accumulated. I'm sure I'll regret it later on. I'm working on several project cars and my basement is overflowing with parts! Getting to "hoarder status" at this point!

Also, just in case if this option interests anyone, I will gladly make deals with people where I buy some of these parts back in the future. We can workout the details if that interests you.

I have a lot of parts, new and used.

Here's a list of parts I don't have:
Ashtray
Cupholder
Driver vent
Lip 00-01
Rear calipers
Rear trailing arms
Swaybars
Engine harness
USDM ECU
Header heat shield
Header
Radiator
Lower chassis stiffening bar
OEM rxhaust
OEM catalytic converter.

A quick list of what I have:
2001 USDM B18C5 longblock
JDM '97 B18C swap. Disassembled longblock. Previous owner said it was burning oil. He took it apart. Full engine, trans, ECU. No engine harness.
2 JDM ECUs. 97 and 2001
Mint USDM Seats front and rear
CW '97 Wheels and center caps avg cond
CW center caps (4) new
Front bumper and hood gaskets new
Bumper stiffening braces new
Strut tower bar (2) and bolts
Rear lower control arms used
ITR Car cover new
Valve covers (6) 3 USDM 3 JDM new
Valve cover gasket OEM new
Brake front dust shields new
Armrest and badge new
Badges red front and rear new
Stickers new
Front upper control arms OEM new
UKDM OEM floor mats (2) new
OEM headunit (3) Canadian Acura EL used
CF Center vent HVAC damaged slightly
'97 CW JDM Hatch and wing wiperless
OEM RDOT painted PY front Fender bad paint
PY Rear trunk garnish with original sticker
Strut tower bar stickers
Intake tube (2) new
Clock used
Shift boots (3) new 00-01
Shift knob (2) '97-'98 new
Shift knob Titanium 00-01
JDM OEM Pistons and rings new
PY OEM sideskirts some damage
USDM and JDM OEM keys (7) all different years
'97-'98 Black new center vent (4) new
Front calipers used
Front rotors OEM new
Distributor cap and rotor OEM new
Spark plug wires and holders OEM new
Windshield trim and roof trim new (6)
Door belt trim (outside where door meets glass) 6
Battery tie down and hardware used
5-lug swap OEM hubs and bearings new
JDM tail lights used
Speedometer ~142K miles not sure the year yet
1/4 rear window. Driver's side only.
Trunk stiffening bar used
Power antenna OEM new
Coolant overflow bottle new
OEM wing gaskets
OEM Rear tail light gaskets

Aftermarket:
Jasma header with the Downpipe flange cut off.

I'm likely going to keep the car cover, frint and rear A badges, seats, armrest, door panels, and the B18C5 longblock until the very last minute. We'll see though.

Just let me know if you're interested in anything and we can go from there.

[98champwhite]

I’m interested in one of the used OEM radios and the power antenna.

Email me if you can
retrospect3.info@gmail.com

[Mugen_ITR]

PM'd Andy, ty in adv.

[tegra7]

Sent you a PM

[aho]

Andy, I sent you a PM.

Good Luck on the purchase!

[Dave7CDMTYPER]

Sending PM now...

[CW FL5 CTR]

Andy, messaged you back but haven't heard from you.

[Dave7CDMTYPER]

Same here, awaiting response.

[coolhandluke]

Hey Andy, please hold the ITR seats for AssPenny. I'll send him here.

[JDMJNKY]

Andy, do you still have the 97 ecu??